Loading and Saving Profiles on Cross|Up


This will be an overview on how to Load and Save information to and from your Cross|Up, so you can put your profile editing and button remapping to the test.

Before you continue, be sure you have the Cross|Up Designer Software: Downloads Page

Loading

The most important thing is that you don't want to overwrite anything that you already have on your Cross|Up. So you'll need to load what you have on your controller into the Designer, and edit from there.

When you have the Designer Software open, and your Cross|Up plugged in using the USB-B port on the side, select "Load Controller" at the top of the window.

This window should pop up. Select "Load Values From Cross|Up."

Once it loads the values, most computers will output an audible cue and it should say "Successfully Read From Controller."

Note: If it fails to load, try the "Use A Specific COM Port" option.

Exit from that window, and profiles and layouts you had on your Cross|Up should be in the Designer for you to edit and customize.

Saving

Once you've done all the customization that you want, you're going to want to save that onto your Cross|Up so you can use and test out your ideas.

With your Cross|Up plugged in to your PC, select "Save Controller" at the top of the Designer window.

This window should pop up. Select "Save Changes to Cross|Up."

Once it saves the values, most computers will output an audible cue and it should say "Successfully Saved To Controller."

Note: If it fails to load, try the "Use A Specific COM Port" option.

Close that window. Everything should be on your Cross|Up now and ready to play!

If you wish to save your layouts to your computer, check out our post "Importing and Exporting Layouts on Cross|Up."

If you have any questions, check out our other information on Cross|Up or contact us through one of profiles.

 



日本語